Replace and upgrade your Vintage or New Technics SL-1900 & SL-1950 Fully Automatic Direct Drive Turntable Feet with Mnpctech Sorbothane Vibration Washers.
Each Technics SL-1900 & SL-1950 upgrade isolation foot measures 1-1/4" tall x 1-3/4" O.D. with machined 6061 grade aluminum shell.
Each Technics SL-1900 & SL-1950 foot has 10/32 thread screws with nylon nuts.
Sold In Set Of Four.
Silver 6061 machined aluminum cover.
Mnpctech Audiophile Technics SL-1900 & SL-1950 Turntable will help eliminate and isolate vibration. Neoprene bottom foot prevents scratches on audio stand or furniture surfaces.
Here are the "How to" steps for removing disintegrated feet on Technics SL-1900 turntable and installing Mnpctech Technics SL-1900 & SL-1950 custom turntable isolation feet.
You must remove the bottom cover of the Technics SL-1900 & SL-1950 to access and remove the factory feet. It's very common for the Technics factory rubber feet to have degraded and rotted away.
Use small flat head screw driver to pry off the metal tab.
Bending the tabs upward will allow the Technics SL-1900 & SL-1950 feet to free. You can see how the old Technics turntable foot factory glue has aged.
Technics SL-1900 & SL-1950 factory turntable foot and metal tab / mounting plate. It's very common to see the technics factory foot now as worn out rubber. This worn out or rotted rubber feet is often the situation with these vintage Technics turntables from the late 70's / early 80's.
Install Mnpctech Technics SL-1900 custom isolation feet with the included 10/32 nylon nuts.
Now you're ready to listen to your analog vinyl records on your Technics SL-1900 with repaired and upgraded isolation feet.
Here's another angle of the custom feet installed in the Technics SL-1900, Fully Automatic Direct-Drive Turntable. Don't waste your time trying to find replacement Technics SL feet on Amazon, Mnpctech is the only source in the world that makes custom replacement rubber isolation feet for the technics SL-1900 and other SL models. Our Technics SL-1900 Feet are made in our family workshop.
Just Ask Siri or Alexa To Find New Technics SL-1900 Feet for you. These Technics SL-1900 direct drive turntable feet are made in our family workshop.
Technics SL-1900 series Turntable in photos not included.
Mnpctech's turntable feet are mentioned by Micheal Fremer as preferred choice over Technics factory feet on their SL-1000R in November issue of Stereophile Magazine cover article.
Made in the USA.
Audiophiles have used our other custom made turntable isolation feet on Akai, Audio Technica, Clear Audio, Crosley, Denon, Dual, Kenwood, Klipsch, Lenco, Marantz, McIntosh, Music Hall, NAD, Panasonic, Pioneer, Pro-ject Audio, JVC, Rega Planar, Sherwood, SONY, TEAC, Technics, Thorens, and Yamaha.